Dengue IgG/IgM/NS1 Combo Rapid Test Kit (DTS349-2402)

My Review for Dengue IgG/IgM/NS1 Combo Rapid Test Kit

Creative Diagnostics products are for RESEARCH USE ONLY, please make sure your review is research based.

For more information, please visit Accu-Tell.

Required fields are marked with *

The Dengue Ag&Ab Combo Rapid Test is a rapid membrane based chromatographic immunoassay for for the qualitative detection of NS1 antigen and IgM/IgG antibodies to all four serotypes (DEN-1, DEN-2, DEN-3 and DEN-4) of Dengue virus in human serum, plasma or whole blood. It is intended to be used by professionals as a screening test and provides a preliminary test result to aid in the diagnosis of primary and secondary Dengue infection.

For professional in vitro diagnostic use only.

Features

Want more information on Dengue Combo Rapid Test Cassette? Feel free to contact us.

• Highly Sensitive & Specific
• Flexible Samply Type
• Fast in 15 minutes
• Simple Operation

Included Materials

• Test Cassette 
• Sample Buffer
• Droppers
• Instruction for Use

Test Procedure 

The test should be operated at room temperature 59-86°F（15-30℃). 1. Allow the test cassette, specimen and buffer to reach room temperature (15-30°C) before testing. 2. Remove the test cassette from the foil pouch and use it as soon as possible.

3. Place the test cassette on a flat and clean surface. Transfer the specimen by a pipette or a dropper:

To use a Pipette:

Are you interested in learning more about dengue rapid test? Contact us today to secure an expert consultation!

4. Transfer 10 μL of Serum, Plasma, or Whole blood specimen into the Sample Well (S) of the test cassette, then add 2 drops of buffer into the Buffer Well (B) and start the timer. Avoid air bubbles in the Sample and Buffer well. To use a Dropper: 5. Hold the dropper vertically and fill the capillary part of the dropper (not to exceed the capillary part) with Serum, Plasma or Whole blood specimen (10 μL), then carefully dispense the specimen into the Sample Well (S) of the test cassette. then add 2 drops of buffer into the Buffer Well (B) and start the timer. Avoid air bubbles in the Sample and Buffer well. 6. Wait for the colored line(s) to appear and read the results at 15 minutes. Do not interpret the result after 20 minutes. If positive signal appears after 20 minutes, it should not be reported as positive.